What is the Cycle Selector and how do I set the Cycle Selector for my Dolphin Liberty 300 and 400?
Liberty 300
On the Liberty 300, Cycle Selector is the option to switch the cleaning mode from Regular (floor, walls, and waterline) to Floor Only.
Liberty 400
The Liberty 400 has an Advanced Cycle Selector.
The three cleaning cycles are:
- Floor Only
- Regular (floor, walls, and waterline)
- Ultra-Clean (cleaning floor, walls, and waterline extra carefully)
You can set the Ultra-Clean cycle through the MyDolphinPlus app only.
See below to switch from Regular to Floor Only.
How to Set the Cycle Selector
- Press the power button ON.
- After the battery level LED lights up, press and hold the power button for 3-4 seconds until the battery LED blinks purple 3x.
This will change the cleaning mode from Regular to Floor Only on the Liberty 300 and 400.
The default mode is Regular (floors, walls, and waterline) so once the power button is pressed again or the robot is connected to the charger – the robot will default back to the Regular cleaning mode.