Aquasweep S1

The AquaSweep is designed for easy, routine maintenance of your pool and spa. Use the vacuum with the extension pole for pools and the short handle for spas.

The vacuum can be used without the brush head to clean pool corners, while the floor brush helps scrub and suction dirt from the pool bottom.

The Aquasweep can be used in above-ground, in-ground pools, hot tubs, and spas. It can also be used in saltwater pools.

The AquaSweep works in water up to 2.4 meter deep and functions best in temperatures between 0°C–40°C.

Always use a filter and replace it if damaged for the best performance.

Avoid vacuuming large, hard, or sharp objects to prevent damage.

Works in water up to 2.4 meters deep and temperatures between 0°C–40°C.

Submerge the vacuum within 15 seconds of turning it on to ensure proper operation.

Charge fully before the first use for optimal results.

Store in an area protected from direct sunlight / rain / frost at storage temperature 0˚−40˚ C.

Charge indoors in a clean, dry, ventilated area (0C°-35C°).

Do not use the cleaner while charging.

1. 1. Turn off the vacuum before charging.
   2. Flip it upside down to drain any water.
   3. Ensure the cleaner and charging port are completely dry before charging.
   4. Lift the soft seal to plug in the charger.
   5. Red light = charging, blue = fully charged.

After charging, seal the port and check the plug to make sure it is securely closed.

Unplug the cleaner when not in use.

It takes about 4-5 hours to fully charge. When fully charged, the device operates for 60 minutes.

Always turn off and unplug from the charger before cleaning, filter replacement or any routine maintenance.

1. 1. Turn off the vacuum, lift the filter lock, and separate the main body.
   2. Remove the filter, press the handle towards the arrow to unlock the cover, lift it off, keeping it facing upward to avoid debris spilling out.
   3. Empty debris, rinse the filter with clean water (avoid sharp objects), and reattach the filter cover.
   4. When reassembling the filter component, ensure it is placed correctly.
   5. Reinstall the main body and securely lock the dust box.

No, the Aquasweep is designed to collect small debris like leaves, sand and bugs for daily maintenance. To treat algae, we recommend consulting with a pool technician for a chemical treatment plan.

To attach the short handle:

1. 1. Attach the handle by pressing the release button and insert it into the back handle of the main body.
   2. If you want to remove the handle, press the release button and remove the handle.

To attach the extender pole:

1. 1. Squeeze the buckle to attach the expansion pipe.
   2. Adjust until locked.
   3. Press the buckle to connect it to the main body.
   4. To remove, press the buckles and detach.
   5. Rotate OPEN to extend, LOCK to secure.

Blinking Red = Low battery

Steady Red = Charging

Steady Blue = Fully Charged

No light = Fully drained

The vacuum is designed for routine pool maintenance, not heavy debris or algae buildup. If there's a large accumulation, the filter may clog or fill up quickly.

Clean multiple times to gradually clear debris. If there is algae, consult with a pool technician for chemical treatment.

Make sure the vacuum is fully charged before use (steady blue light on LED indicator).

Ensure the vacuum is submerged in water (past the LED indicator). If the vacuum is out of water, it will shut down within 15 seconds as a fail safe.

This can be caused by a clogged filter. Clean the filter according to the filter cleaning steps.