The Tracker 15 is suitable for above-ground pools that have a completely flat surface. The pool can be up to 6 m long. The water level of the pool should also be at least 0.4 -2.5 m above the device.

The warranty on the Tracker 15 is 24 months.

Follow these steps to charge the Tracker 15 properly:

When you remove the cleaner from the pool, turn it off with the power button at the bottom.

Wait 20 minutes after the end of the cleaning cycle before charging the device.

Charge the device in a cool area indoors.

Do not cover the device while charging to prevent the components from overheating.

1. Turn the cleaner off before charging and ensure the water spray flaps of the cleaner do not touch the ground.

2. Connect the cleaner to the electrical socket using the provided battery charger only.

If the LED on the charger is RED, the device is not fully charged – charging in progress.

If the LED on the charger is solid GREEN, the device is fully charged. Once it reaches a full charge, after 10 minutes the LED will turn off automatically.

The charge time for the Tracker 15 is 2-2.5 hours long. The cleaning cycle time is 60 minutes.

Place the Tracker 15 on a solid, dry surface. Make sure it is switched OFF.

Complete the following steps:

1. Remove the filter cover by lifting the buckles on the sides to pull the lid off.

2. Remove the filter to rinse the debris. Rinse the debris from the filter and the filter body with a garden hose.

3. Put the lid back on by aligning the clips with the filter body, until it clicks shut.

We recommend cleaning the filter after each cleaning cycle for the best cleaning results!

Follow these steps to install a new filter:

1. Align the filter cards with the slots on the filter body.

2. Align the slots on the device body with the filter slots and push them together.