The Tracker is designed to make pool cleaning effortless and efficient with its advanced technology. Equipped with three brushless motors—dual driving motors and a single suction motor—it delivers powerful performance while keeping maintenance low, combined with an ECO mode feature. Its Smart Sonar Navigation allows it to detect walls before reaching them, enabling the robot to make precise turns. Plus, with its convenient self-parking feature, retrieval is a breeze.

The Tracker 25 is suitable for flat surface above-ground pools and small in-ground pools, up to 8 m long. The water should be at least 0.4 -2.5 m above the device.

The warranty on the Tracker 25 is 24 months.

Charge your Tracker 25 in a shaded, dry area. Do not use an extension cord to connect the battery charger to the electrical socket. For user safety, place the battery charger at least 11 cm above the ground while in use.

1. Connect the robot to the electrical socket using the provided battery charger. The LED on the robot will flash GREEN during the charging process.

2. When the device is fully charged, the LED on the robot will show steady GREEN. After 10 minutes, it will turn off automatically.

3. Disconnect the charger from the robot and the electrical socket.

The Tracker 25 has a charge time of 4 hours. Once fully charged, it cleans the floor only for up to 90 minutes, ensuring your pool stays sparkling with minimal effort.

The Tracker 25 offers two cleaning settings: Standard Mode and Eco Mode.

Standard Mode: This mode provides up to 1.5 hours of floor-only cleaning.

Eco Mode: With Eco Mode, the Tracker 25 completes two shorter floor-only cleaning cycles on a single battery charge.

Carefully follow the instructions below to clean the impeller.

1. Turn OFF the robot: Press and hold the button until the LED turns off.

2. Clean the sensors: Wipe the metallic out-of-water sensors on the robot's top with a tissue to ensure they are completely dry.

3. Remove the impeller cover: Remove 2 screws to take off the impeller cover.

4. Carefully remove debris from the impeller area (with a tweezer or a similar tool). Gently return the cover and screws.

Solid Display:

Blue - Device working
Red - Device Error
Green - While Working: ECO mode, While connected to the charger: Fully charged
Purple - Device Stuck During Operation

Flashing Display:

Blue - Flash every 1 sec: Device Starting. Flash every 3 sec: Device Idle. Flash every 30: Device idlein ECO mode
Green - Device charging
Yellow - Low Battery
Purple - Cleaning mode has changed
White - Software Update